The following tutorial goes through a step by step process of how to configure an automed adapter. If at anytime you have issues in trying to carry out this task, please contact our support team for help [email protected]
Connect your automed Device to the automed App. Once connected clip on your new adapter to the automed Delivery Device.
Click the Adapter button to begin configuring a new adapter. Choose from a listing of your medicine inventory (set up from your web portal) for your automed account. Click here for instructions on how to add inventory to your automed account.
To configure an adapter, first, pick a medication from the listing, in the pop-up, click Yes to confirm that you have chosen the correct medication. Then tap the Configure Adapter button at the bottom of the screen.
If the medication that you selected is a Fixed Dose the LED light will turn green and your device will say Ready to Dose.
If the medication that you selected is a Weight Based: you’ll need to specify a dosing method: Manual to administer a fixed dose, or Bluetooth Scale or WiFi Scale to give a weight-based dose. See the figure below.
If you tap Manual, then you’ll need to enter a dose that is less than or equal to the capacity of the adapter.
Confirmation from the adapter
If the adapter has been used, then the device will display a message to “Configure adapter using app”. The device will beep four (4) times if the configuration is successful. If the adapter has been previously configured, then the device will beep three (3) times only.
Adapters are configurable for one medication only
If an adapter has been previously configured for dispensing medication, then it is not possible to change its medication without returning it to automed. If you attempt to reconfigure an adapter for a different medication, then you’ll get an error message, “Wrong Medication Code”. on the app and the device will display the message, “Adapter Configured for another medication”.